UV system LAMPcure


The new UV sheet-fed-drying system represents a further optimisation of our proven technology when it comes to output and energy usage. Only two individual plug-in modules with an output of 200 W/cm each are normally used for sheet-fed end-of-press drying. The UV output generated is comparable with a common three-lamp system. Significant energy savings can therefore be achieved, depending on the application.



All advantages at one glance


FLC Fast Lamp Change

The cordless FLC (Fast Lamp Change) UV lamp system enables uncomplicated and fast lamp changes in just a few seconds.


IST Metz provides a warranty for 10,000 operating hours on URS type reflectors and 2,500 operating hours on UV lamps.


The new UV system features efficient heat management. Cooling the shutter and the reflectors with water dissipates the resulting heat directly and effectively out of the machine. The integrated air cooling ensures uniform operation of the UV lamp.

Electronic power supply devices

Linked to the printing speed, the ELC controller can continuously adjust the lamp output between around 30 and 100%. In standby mode, the power is automatically reduced to a minimum.

UV measurement – optional

The UV system is prepared for UV measurement by default. The portable UMS-2 UV measuring instrument enables you to easily check the UV power if required. The precisely defined sensor position means that comparative measurements can be taken at any time.

Deep Cure Paket – optional

An UV package specially designed for deep curing of thick print layers is available for optimum drying of opaque white.

Flexible Shutter Positioning FSP – optional

The new FSP system for end-of-press, features an exceptionally large reflector opening angle. When printing on temperature-sensitive materials, the shutters can be used to limit this opening angle, in order to minimise the influence of the temperature on the substrate.

Hot Swap Technology

Hot Swap Technology enables the operation of LAMPcure and LEDcure systems for sheet-fedprinting. LAMPcure can easily be retrofitted to a LEDcure system.

Retrofit when using an ELC-X/PE electronic power supply device

Existing UV units that are already operated with the ELC-X/PE series can be retrofitted by a LEDcure system.

Water-cooling for lamps and LEDs

Water-cooling of the LED chips for high efficiency and a long life time of the system.

Smart Control

The new generation of LAMPcure/ LEDcure can be equipped with the Smart Control system user interface. This makes the operation of UV systems clear, it is easy to use and it allows straightforward integration into the control systems of all common kinds of printing press.